Electric Slide Room System; Troubleshooting The Slideout; Slideout Systems - Jayco 2016 Melbourne Owner's Manual

e s
lectric lide
Make sure the interior slideout room path and the slideout room itself is clear
of people and objects before operating. Keep away from the slide rails and
gear assembly when the room is in motion. They may pinch or catch on loose
clothing causing personal injury. Failure to follow these instructions could
result in serious injury or death.
Make sure the motor home is level before operating the slideout room. Water
leaks and other problems could result if the slideout is operated without
leveling the motor home...
Do not place excessive weight in the slideout room. It can cause the slideout
room to malfunction and cause damage to the slideout.
The slideout room system is designed for additional floor space and comfort. The mechanical
components are gear driven. Electric powered slideout room systems have a manual override
to allow you to extend or retract the slideout room(s) in case of a power loss. Make sure you
have sufficient power available before operating your slideout system.

Troubleshooting the Slideout

If the slideout does not move when the slideout switch is depressed, follow these steps.
Check the auxiliary battery (customer supplied) for a full charge and good wire
connections.
Check the 12-volt fuse or circuit breaker.
Check for loose connections at the slideout motor.
If the slideout still will not operate, follow these steps.
If the slideout is extended, refer to the section on operating the specific slideout
system installed on your RV.
If the slideout is retracted, leave it in that position.
Contact your dealer or customer service for repair assistance.Your motor home
may include one or more of the following slideout systems.
s s
lideout ysteMs
Schwintek Inwall slideout system
The in-wall slideout system requires no maintenance it will never require any adjustments.
The in-wall system has two vertical columns. Each side has a drive motor located at the top
of the column. The right hand and left hand motors remain synchronized by the dual motor
synchronous velocity slide controller (a circuit board typically located in the basement area
Maintenance Record
r s
ooM ysteM



Table of Contents
S S
lideOut yStemS
53