Replacing Light Bulbs - Jayco CLASS C2013 GREYHAWK Owner's Manual

SECTION 6 – 30 AMP ELECTRICAL SYSTEM
Excessive cranking can overheat and damage the generator starter motor. Do
not crank for more than 20 seconds at a time. Wait at least two minutes
before trying again. If the genset does not start after the third try, refer to the
generator manufacturer's user manual for more information.
To start the generator manually
1. A remote start/stop switch is located inside the motor home. A second
start/stop switch is located on the generator.
2. Press the operation control switch to start the generator.
3. The hour meter will monitor minutes of usage when the generator is running.
For top performance and engine life, especially in colder weather, let the genset
engine warm up for two minutes before connecting (turning "on") appliances.
Maintenance
With the exception of simple items such as normal maintenance (i.e., oil changes,
etc.), all service work should be done by a repair facility authorized by the
generator OEM. Improper adjustments can damage the generator and electrical
appliances, and can result in a safety hazard. If any discrepancy or problem is
noted, contact your dealer for assistance.
I (I E
NVERTER F SO
You motor home maybe equipped with a factory-installed inverter that converts
12-volt DC current to 120-volt AC current. It is important that you familiarize
yourself with the inverter function and operation. The inverter should be "off" when
not in use.
The factory-installed inverter is not intended for use with medical device(s).
12- DC O
VOLT UTLET
There may be a 12-volt DC outlet (not applicable on all models) in your motor
home. When the 12-volt DC outlet is used as a power source for an electric
appliance, make sure that the appliance operates on 12-volt DC power and that it
consumes less than 60 watts (5 amps) of 12-volt power. To prevent short circuits
do not allow metallic foreign matter to get into the 12-volt DC outlet.
R L
EPLACING IGHT
Before replacing a bulb, be sure the light is off. Do not touch the glass part of the
new bulb with your bare fingers.
The skin oil left on the glass will evaporate when the bulb gets hot, the vapor will
condense on the reflector and it will dim the surface. Replace a bulb only with a
new bulb of the same rating and type.
GH/M
)
QUIPPED
(I S E
F O QUIPPED
B
ULBS
CAUTION
)
6-10
CLASS C MOTOR HOME