Handlebar Switches - Yamaha MT-07 Owner's Manual

INSTRUMENT AND CONTROL FUNCTIONS

Handlebar switches

Left
1
3
2
3
4
1. Pass switch " "
2. Dimmer switch " /
3. Turn signal switch " /
4. Horn switch " "
Right
1. Start/Engine stop switch "
2. Hazard switch " "
EAU1234G
Pass switch "
Press this switch to flash the headlight.
Dimmer switch "
Set this switch to "
beam and to "
Turn signal switch "
To signal a right-hand turn, push this
switch to "
turn, push this switch to "
released, the switch returns to the cen-
"
ter position. To cancel the turn signal
"
lights, push the switch in after it has re-
turned to the center position.
Horn switch "
Press this switch to sound the horn.
1
Start/Engine stop switch "
To crank the engine with the starter,
set this switch to "
the " " side of the switch. See page
2
5-1 for starting instructions prior to
/ / " starting the engine.
EAU12351
"
EAU12401
/ "
" for the high
" for the low beam.
EAU12461
/ "
". To signal a left-hand
". When
EAU12501
"
EAU54211
/ / "
", and then push
3-13
Set this switch to " " to stop the en-
gine in case of an emergency, such as
when the vehicle overturns or when the
throttle cable is stuck.
The engine trouble warning light will
come on when the key is turned to
"ON" and the start switch is pushed,
but this does not indicate a malfunc-
tion.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
EAU41701
EAU12734
" posi-
ECA10062