Yamaha MT-07 Owner's Manual page 87

4
1. Brake hose holder
2. Bolt
3. Brake caliper
4. Brake caliper bolt
4. Remove the brake caliper on each
side by removing the bolts.
NOTICE: Do not apply the brake
after the brake calipers have
been removed, otherwise the
brake pads will be forced shut.
[ECA11052]
5. Pull the wheel axle out, and then
remove the wheel.
To install the front wheel
1. Lift the wheel up between the fork
legs.
2. Insert the wheel axle from the right
side.
PERIODIC MAINTENANCE AND ADJUSTMENT
3. Lower the front wheel so that it is
on the ground, and then put the
sidestand down.
1
4. Install the brake calipers by install-
ing the bolts.
2
TIP
Make sure that there is enough space
between the brake pads before install-
3
ing the brake calipers onto the brake
discs.
5. Install the brake hose holder by in-
stalling the bolt.
6. Tighten the brake caliper bolts and
the brake hose holder bolt to the
specified torques.
Tightening torques:
Brake caliper bolt:
40 Nm (4.0 m·kgf, 29 ft·lbf)
Brake hose holder bolt:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
7. Tighten the wheel axle, and then
the wheel axle pinch bolt to the
specified torques.
6-38
Tightening torques:
Wheel axle:
65 Nm (6.5 m·kgf, 47 ft·lbf)
Front wheel axle pinch bolt:
23 Nm (2.3 m·kgf, 17 ft·lbf)
8. Push down hard on the handlebar
several times to check for proper
fork operation.
6