Rear Wheel (For Non-Abs Models) - Yamaha MT-07 Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
Rear wheel (for non-ABS
models)
WARNING
For the ABS model, have a Yamaha
dealer remove and install the wheel.
To remove the rear wheel
WARNING
6
To avoid injury, securely support the
vehicle so there is no danger of it
falling over.
1. Loosen the locknut and drive
chain slack adjusting nut on each
side of the swingarm.
2. Loosen the axle nut.
EAU44802
1
EWA14841
4
EAU59940
1. Drive chain slack adjusting plate
2. Drive chain slack adjusting nut
3. Locknut
EWA10822
4. Axle nut
3. Lift the rear wheel off the ground
according to the procedure on
page 6-36.
4. Remove the axle nut and the drive
chain slack adjusting plate.
5. Push the wheel forward, and then
remove the drive chain from the
rear sprocket.
2 3
TIP
 If the drive chain is difficult to re-
 The drive chain does not need to
6. While supporting the brake caliper
6-39
move, remove the wheel axle first,
and then lift the wheel upward
enough to remove the drive chain
from the rear sprocket.
be disassembled in order to re-
move and install the rear wheel.
and slightly lifting the wheel, pull
the wheel axle out and remove the
drive chain slack adjusting plate.