Storage; Service Parts; Accessories - Ariens Sno-Thro 921001 – ST824E Owner's/Operator's Manual

5. Disconnect pivot pin from the speed selector arm.
Save the hardware for reinstallation.
6. Remove spring clip pin nearest drive sprocket
from hex shaft.
7. Remove left bearing flange from frame.
8. Slide hex shaft to the left to remove pinion
sprocket and friction disc assembly from hex
shaft.
9. Remove friction disc assembly from frame.
10. Remove three screws holding friction disc to
carrier bearing.
11. Remove old friction disc. Put the friction disc in
place, cup side to carrier bearing.
12. Reinstall three screws into new friction disc and
carrier bearing.
13. Insert new friction disc assembly into frame.
Install washers into carrier bearing and slide into
speed selector arm.
14. Replace bottom cover.
15. Adjust traction drive clutch (see Traction Drive
Clutch Adjustment on page 26).
1
5
2
4
1. Hex Shaft
2. Bearing Cap
3. Speed Selector Arm

STORAGE

WARNING: AVOID INJURY. Read and
understand the entire Safety section before
proceeding.
SHORT TERM
IMPORTANT: NEVER spray unit with high pressure
water or store unit outdoors.
3
6
4. Friction Disc
5. Spring Clip
6. Drive Plate Assembly
Figure 46
Run with attachment clutch engaged a few minutes
after each use to free unit of any loose or melting snow.
Close fuel shut-off valve.
Inspect unit for visible signs of wear, breakage or
damage.
Keep all nuts, bolts and screws properly tightened and
know unit is in safe working condition.
Store unit in a cool, dry protected area.
LONG TERM
Clean unit thoroughly with mild soap and low pressure
water and lubricate (see MAINTENANCE on page 18).
Touch up all scratched painted surfaces.
Remove weight from wheels by putting blocks under
frame or axle.
Fuel System
Gasoline left in the fuel system for extended periods
without a stabilizer will deteriorate, resulting in gum
deposits in the system. These deposits can damage
the carburetor and the fuel hoses, filter and tank.
Prevent deposits from forming in the fuel system during
storage by adding a quality fuel stabilizer to the fuel.
Follow the recommended mix ratio found on the fuel
stabilizer container.
To treat the fuel system for storage:
1. Add fuel stabilizer according to manufacturers'
instructions.
2. Run engine for at least 10 minutes after adding
stabilizer to allow it to reach the carburetor.
NEVER store the engine with fuel in the fuel tank inside
of a building with potential sources of ignition.
Order the following parts through your Dealer:
Part No.
00036800
21533400
07200431
07200111
00170800
OS7142
52100100
See your authorized Ariens dealer to add the additional
accessories available to your Sno-Thro.
Part No.
72406500
72406900
GB - 29

SERVICE PARTS

Description
Ariens Hi-Temp Grease (3, 3 oz. cartridges)
Spark Plug
Impeller Belt (2)
Traction Belt
Friction Disc
Shear Bolt Kit

ACCESSORIES

Description
Front Weight Kit
Slicer Bar