Getting
Safety
Started
Step 1
Step 3
Step 5
Battery
Installation
Installation
1
2
3
4
Step 2
5
6
Desktop mounting instructions
1
Step 4
2
Touchstone TG1672 Telephony Gateway User's Guide
Ethernet
Configuration
Usage
Position the mounting bracket on the surface where you intend to mount
the Telephony Gateway and mark the two holes with a pencil.
Drill holes for the mounting screws through the marked locations.
If using drywall anchors, set them into the wall. Then, drive the screws into
the wall leaving a gap of about 1/8" (3 mm) between the screw head and
the wall. If not using anchors, just drive the screws.
Slip both mounting slots in the back of the mounting bracket over the
screws, then slide the bracket down until the narrow end of the keyhole slot
contacts the screw shaft.
Hang the Telephony Gateway on the wall by inserting the six tabs on the
mounting bracket into the six slots in the back of the Telephony Gateway and
sliding the Telephony Gateway down until it drops in place on the bracket.
Proceed to
Connecting the Telephony
Position the Telephony Gateway so that:
•
it stands vertically on its base (Do not position it flat on its side.)
•
air flows freely around it
•
the back faces the nearest wall
•
it will not fall to the floor if bumped or moved
•
the ventilation holes on the sides of the unit are not blocked
Proceed to
Connecting the Telephony
Troubleshooting
Glossary
Gateway.
Gateway.
23