Battery Installation And Replacement - Arris Touchstone TG1672 User Manual

Getting
Safety Started
Battery Slots
Battery
Pull Strap
Battery
Installation Installation

Battery Installation and Replacement

Use this procedure to install or replace the backup battery.
Latch End
1
2
3
Battery Guides
Touchstone TG1672 Telephony Gateway User's Guide
Ethernet
Configuration Usage
Press down and pull back on the latch holding the battery door (on the bot-
tom of the Telephony Gateway). Pull the door toward you. Set the door aside
in a safe place.
CAUTION
Risk of equipment damage
Improperly inserting the battery may damage the battery connector in
the Telephony Gateway. Carefully follow the instructions in the next
step to avoid damage.
Hold the battery pack so that the guides on the battery align with the slots
on the Telephony Gateway and slide the battery into the bay. The diagram
on the left shows the proper orientation.
Note: Batteries will not insert completely into the Telephony Gateway if not
oriented correctly. The battery should slide into the bay without significant
force. Line up the slots in the battery bay with the guides on the battery
and apply even pressure on both ends of the battery.
Push the battery pack into the bay until it latches into place. If you are
taking the battery out of the Telephony Gateway, use the battery
pull strap to dislodge the battery.
Note: The Telephony Gateway will not begin operating until you apply AC
power.
Troubleshooting Glossary
15