Table of Contents
Advertisement
- Fit the 2 centring pins (2) to the LH casing and
a new paper gasket (3) do not use oil or
grease.
- Place the RH casing over the LH casing
assembly.
Note: No tools are necessary for assem-
bling the casings, which shall be car-
ried out without effort.
- Fit and tighten the 8 fixing bolts .
- Tightening torque: 1 m.daN.
- Check the crank assembly turns freely in the
casings.
- Trim the casing gasket in (A).
- Lightly grease the crank assembly and
bearings with 4 stroke oil.
- Place the inlet pipe and the O-ring (check the
condition of the O-ring and if necessary
change it)..
- Tightening torque: 1 m.daN.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
REFITTING SPECIFIC COMPONENTS
2
3
A
2
31
Hide quick links:
Advertisement
Table of Contents
