Table of Contents
Advertisement
DISASSEMBLY
Remove:
- The upper cup (1).
- The spring (2) (when dismantling notice in
which direction it is so that you will replace it in
its initial position when reassembling).
- The lower washer (3).
- The valve (4).
- Remove the 2nd valve in the same way.
Note: When re-installing, lubricate the
2 half cones (5) so as to hold them in
the groove of the valve's stem.
Do not place the 2 half cones into the cup
forcefully with the tool when decom-
pressing the spring.
In case you remove the seal of a valve stem (6),
replace it with a new seal after removing all the
carbon residues which could remain inside the
cylinder head.
Important: When re-installing, the camshaft
bearings, the rocker shafts and the
contact between the rockers and the
valves shall well lubricated in order
to avoid any risk of seizure when
starting the engine (use a Molykote
type grease). Seals and valve stems
must be lubricated.
18
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
1
4
5
6
2
3
5
Hide quick links:
Advertisement
Table of Contents
