Auto Standby Function; Locking Disc Ejection - JVC DD-1 Instructions Manual

Auto standby function

If no sound is produced for 3 minutes, the main
unit automatically turns off.
This function is available when a disc/file is
selected as the source.
You cannot use this function when a radio broad-
cast or a device connected to the [LINE IN 1],
[LINE IN 2] or [LINE-DIGITAL IN] terminals is
selected as the source.
Activating the auto standby function
■When a disc/file is selected as the source
Press [A.STANDBY].
.
• Pressing [A.STANDBY] once again deactivates
the function. (The display window changes to
"A.STANDBY OFF".)
Performance of the auto standby
function
When playback of a disc/file finishes, the auto
standby function starts a countdown.
At this time, the "A.STANDBY" indicator
starts flashing.
20 seconds before the main unit turns off,
"A.STANDBY" starts flashing.
When no operation is carried out for 3 minutes, the
main unit automatically turns off.
NOTE
• Leaving the volume at "0" is not the same as
producing no sound, and therefore does not start
the auto standby function.
"A. STANDBY" indicator
For the locations of the remote
control buttons, refer to page 17.

Locking disc ejection

You can lock the disc tray to prevent the disc from
being ejected.
Setting the disc ejection lock
■When the main unit is turned off
Press 0 while holding down
main unit.
• Repeat this step to cancel the disc ejection lock.
(The display window changes to "UNLOCKED".)
7
on the
20