Common Operations; Setting The Clock - JVC CA-UXHB4 Instructions Manual

Common Operations

Setting the Clock

Before operating the unit any further, first set the unit's clock.
When you plug in the power cord, "0:00" starts flashing on
the display.
You can set the clock when the unit is in standby mode.
On the remote control ONLY:
1
Press CLOCK for more than 2
seconds.
Clock setting appears on the display.
2
Press UP or DOWN to select the
clock synchronization setting,
then press SET.
On The unit's clock is adjusted
automatically with the FM RDS
signal on next time you tune in to an
FM station.
Off The unit's clock is adjusted manually.
The time system indication starts flashing.
3
Press UP or DOWN to adjust the
time system, then press SET.
12H The hour indication is displayed with
a 12-hour system (with "AM" or
"PM").
24H The hour indication is displayed with
24-hour system.
The hour indication starts flashing.
4
Press UP or DOWN to adjust the
hour, then press SET.
• When you press and hold UP or DOWN,
the hour indication changes continuously.
• The clock is working even while setting.
The minute indication starts flashing.
9
5
Press UP or DOWN to adjust
the minute, then press SET.
• When you press and hold UP or DOWN, the
minute indication changes continuously.
CLOCK
The day of the week indication starts flashing.
6
Press UP or DOWN to adjust
the day of the week, then press
SET.
UP
SEARCH/ SEARCH/
SCROLL SCROLL
PRESET
DOWN UP
GROUP
/
SELECT Display brightness setting when the unit is in
DOWN
PRESET
standby mode appears on the display.
GROUP
• If you want to change the time setting, press
CANCEL repeatedly to return step 2 .
7
Press UP or DOWN to adjust
SET
the brightness, then press SET.
The brightness level can be adjusted
between "0" (canceled) to "3" (most bright).
The greater number you set, the brighter the
display is.
UP
SEARCH/ SEARCH/
SCROLL SCROLL
PRESET
DOWN UP
GROUP
/
SELECT
DOWN
PRESET
GROUP
The unit's clock starts working with the time you
adjusted.
SET
• When you unplug the AC power cord or if a power failure
occurs
The clock is reset to "0:00." If this happens, set the clock again.
• The clock may gain or lose 1 to 2 minutes per month (when
the clock synchronization is turned off)
If this happens, set the clock again.
UP
SEARCH/ SEARCH/
SCROLL SCROLL
PRESET
DOWN UP
GROUP
/
SELECT
To adjust the clock
DOWN
PRESET
GROUP
On the remote control ONLY:
1
Press CLOCK for more than 2 seconds
when the unit is in standby mode.
SET
Clock setting appears on the display.
2
Repeat steps 2 to 7 of "Setting the Clock"
procedure.
UP
SEARCH/ SEARCH/
SCROLL SCROLL
PRESET
DOWN UP
GROUP
/
SELECT
DOWN
PRESET
GROUP
SET
UP
SEARCH/ SEARCH/
SCROLL SCROLL
PRESET
DOWN UP
GROUP
/
SELECT
DOWN
PRESET
GROUP
SET
UP
SEARCH/ SEARCH/
SCROLL SCROLL
PRESET
DOWN UP
GROUP
/
SELECT
DOWN
PRESET
GROUP
SET
CLOCK