Ford Windstar User Manual page 140

Seating and safety restraints
Replacing the second row bench seat belt assemblies after a
collision
All second row bench seat belt assemblies adjacent to a sliding door have
special energy management retractors designed to further reduce the
risk of injury in the event of a head-on collision. These retractors should
be replaced if they were used in any accident in which the front airbags
deploy. If the safety belt assemblies are not replaced, there may be
increased risk of injury in the event of a subsequent collision.
Failure to inspect and if necessary replace the safety belt
assembly under the above conditions could result in severe
personal injuries in the event of a collision.
AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS)
4 5 6
3
FUEL TRAC
F
2 ACTIVE
TRAC
OFF
1
RPMX1000
E
mi
AUTO P
Your vehicle is equipped with a crash sensing and diagnostic module
which records information about the air bag and sensor systems. In the
event of a collision this module may save information related to the
collision including information about the air bag system and impact
severity. This information will assist Ford in the servicing of your vehicle
and may help Ford better understand real world collisions and further
improve the safety of future vehicles.
140
O/D
OFF
60
INFO
40 80
TEMP
7
80
120 H
BRAKE
SETUP
20 100
40
160
THEFT
RESET
MPH
km/h
VOL - PUSH ON DISC
OFF EJ
FM1
FM1 ST
ST MUTE
T/C
AM FM
DOLBY B NR EJ TAPE CD AUTO
SEEK
CLK
TUNE SCAN
BASS TREB SEL BAL FADE
REW FF SIDE 1-2 COMP SHUFFLE
1 2 3 4 5 6
MAX
FRONT
A/C
REAR
OFF REAR
CONT
A/C