Perkins 1106A-70T Operation And Maintenance Manual page 52

52
Refill Capacities
Fluid Recommendations
All of these improvements allow the API CH-4 oil to
achieve optimum oil change intervals. API CH-4 oils
are recommended for use in extended oil change
intervals. API CH-4 oils are recommended for
conditions that demand a premium oil. Your Perkins
dealer or your Perkins distributor has specific
guidelines for optimizing oil change intervals.
Some commercial oils that meet the API
classifications may require reduced oil change
intervals. To determine the oil change interval, closely
monitor the condition of the oil and perform a wear
metal analysis.
NOTICE
Failure to follow these oil recommendations can
cause shortened engine service life due to deposits
and/or excessive wear.
Total Base Number (TBN) and Fuel Sulfur
Levels for Direct Injection (DI) Diesel
Engines
The Total Base Number (TBN) for an oil depends on
the fuel sulfur level. For direct injection engines that
use distillate fuel, the minimum TBN of the new oil
must be ten times the fuel sulfur level. The TBN is
defined by "ASTM D2896". The minimum TBN of the
oil is 5 regardless of fuel sulfur level. Illustration 25
demonstrates the TBN.
Illustration 25
(Y) TBN by "ASTM D2896"
(X) Percentage of fuel sulfur by weight
(1) TBN of new oil
(2) Change the oil when the TBN deteriorates to 50 percent of the
original TBN.
Use the following guidelines for fuel sulfur levels that
exceed 1.5 percent:
• Choose an oil with the highest TBN that meets one
of these classifications: EMA DHD-1 and API CH-
4.
• Reduce the oil change interval. Base the oil
change interval on the oil analysis. Ensure that the
oil analysis includes the condition of the oil and a
wear metal analysis.
Excessive piston deposits can be produced by an oil
with a high TBN. These deposits can lead to a loss of
control of the oil consumption and to the polishing of
the cylinder bore.
Operating Direct Injection (DI) diesel engines with fuel
sulphur levels over 0.5 percent will require shortened
oil change intervals in order to help maintain ad-
equate wear protection.
Table 17
Percentage of Sulfur in the fuel Oil change interval
Lower than 0.5
0.5 to 1.0
Greater than 1.0
Lubricant Viscosity Recommendations
for Direct Injection (DI) Diesel Engines
The correct SAE viscosity grade of oil is determined
by the minimum ambient temperature during cold
engine start-up, and the maximum ambient
temperature during engine operation.
Refer to Table 18 (minimum temperature) in order to
determine the required oil viscosity for starting a cold
engine.
Refer to Table 18 (maximum temperature) in order to
select the oil viscosity for engine operation at the
highest ambient temperature that is anticipated.
Generally, use the highest oil viscosity that is
available to meet the requirement for the temperature
at start-up.
g00799818
Table 18
EMA LRG-1
API CH-4
Viscosity Grade
SAE 0W20
SAE 0W30
SAE 0W40
SEBU8728
NOTICE
Normal
0.75 of normal
0.50 of normal
Engine Oil Viscosity
Ambient Temperature
Minimum Maximum
−40 °C (−40 °F) 10 °C (50 °F)
−40 °C (−40 °F) 30 °C (86 °F)
−40 °C (−40 °F) 40 °C (104 °F)
(continued)