Parameters Relating To Fans - York YLCA Technical Information

1 Technical Information
1.13 Operating instructions

Parameters relating to fans

Display Description
Fan outlet:
0= Absent (function not available
F01
1= Present
Operating mode:
0=Always ON (function not available)
1= parallel to the compressor (function not
available)
F02
2=ON/OFF operation (function not availa‐
ble)
3= parallel to the compressor and speed
adjustment
F03 Minimum Triac voltage
F04 Maximum Triac voltage
Minimum speed temp, cool cycle
F05
Minimum speed pressure, cool cycle (1)
Maximum speed temp differential, cool cy‐
cle
F06
Maximum speed pressure differential, cool
cycle (1)
Fan stoppage temp differential, cool cycle
F07
Fan stoppage pressure differential, cool cy‐
cle (1)
F08 Minimum speed temp, heat cycle
F09 Maximum speed differential, heat cycle
F10 Fan stoppage temp differential, heat cycle
F11 Fan start-up time
F12 Triac impulse duration
Fan management in defrost mode:
0= fan disabled
1= fan enabled in cool cycle mode (function
F13 not available).
2= fan disabled until the defrost end tem‐
perature is reached and with top-speed
start-up during d16
Fan operating when starting with high am‐
F14
bient temperature
(1) Parameters to be checked when pressure probes are to be used (low ambient accessory) YLCA 5 to 15.
A Fan speed
B Condensing temperature
C Evaporation temperature
56
Parameters relating to fans
Level VS Unit
F 10 (R/W)
U 48 (R/W)
F 49 (R/W) step
F 50 (R/W) step
°C
F 24 (R/W)
bar
°C
F 26 (R/W)
bar
°C
F 28 (R/W)
bar
F 30 (R/W) °C
F 32 (R/W) °C
F 34 (R/W) °C
F 51 (R/W) Seconds
F 52 (R/W) Seconds
F 53 (R/W)
U 91 (R/W) Seconds
A
A
Max. Min. Value
1 0 1
3 0 3
F04 0 35
100 F03 85
30
80 -40
22,2
15
50 0
3,7
10
50 0
6,5
80 -40 6
50 0 3
F08 0 6
120 0 10
10 0 2
2 0 2
999 0 30
B
C