Using The Timers; Using Daily Timer - JVC CA-MXJ30 Instructions Manual

Using the Timers

There are three timers available — Recording Timer, Daily
Timer, and Sleep Timer.
Before using the timers, you need to set the clock built in the
unit. (See page 9.)

Using Daily Timer

With Daily Timer, you can wake to your favorite music or
radio program.
How Daily Timer actually works
The unit automatically turns on, set the volume level to the
preset level, and starts playing the specified source when the
on-time comes (the indicator flashes just before the on-
time, and continues flashing while the timer is operating).
Then, when the off-time comes ("OFF" flashes just before the
off-time), the unit automatically turns off (stands by).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 1
again.
• If you have made a mistake while setting timer, press
CANCEL. (However, this does not always work. If
CANCEL does not work, press TIMER/CLOCK repeatedly
and start from step 1 again.)
On the unit ONLY:
1
Press TIMER/CLOCK until
"DAILY" appears on the display.
S.MODE
DAILY
ST
The DAILY indicator also starts flashing on the display.
• Each time you press the button, the timer setting modes
change as follows:
DAILY
Canceled
2
Press TIMER/CLOCK again.
"ON TIME" appears for 2 seconds, then the unit
enters on-time setting mode.
S.MODE
DAILY
ST
S.MODE
DAILY
ST
EN18-24.CA-MXJ30/330/35R[E]/f
TIMER
/CLOCK
ON TIME REC
Clock
ON TIME
setting
(See page 9.)
TIMER
/CLOCK
20
3
Set the on-time you want the unit
to turn on.
1) Press 4 or ¢ to set the hour, then
press SET.
2) Press 4 or ¢ to set the minute, then press
SET.
"OFF TIME" appears for 2 seconds, then
the unit enters off-time setting mode.
4
Set the off-time you want the unit
to turn off (on standby).
1) Press 4 or ¢ to set the hour, then
press SET.
2) Press 4 or ¢ to set the minute, then press
SET.
The unit enters source selecting mode.
S.MODE
DAILY
ST
5
Press 4 or ¢ to select the
source to play, then press SET.
• Each time you press 4 or ¢, the
source changes as follows:
TUNER FM
AUX TAPE
TUNER FM: tunes into a specified preset FM
station. = go to step 6.
TUNER AM: tunes into a specified preset AM (MW/LW)
station. = go to step 6.
– CD – – –: plays a disc from a specified track of a
specified disc. = go to step 6.
• Make sure there is a CD on the selected disc
number tray.
TAPE: plays a tape in deck A or B. = go to step 7.
• Make sure that a tape is in the deck whose deck
indicator (A or B) is lit on the display.
• Make sure that the tape direction is correct.
AUX: plays an external source.= go to step 7.
• To use this setting, the external component has to
be equipped with the timer function.
– 20 –
99.2.19, 4:59 PM
Continued
PRESET
SET
PRESET
SET
PRESET
TUNER AM
SET
– CD – – –