Connecting Other Equipment; Adjusting The Voltage Selector; Cancelling The Display Demonstration - JVC CA-MXG65V Instructions Manual

Connecting Other Equipment

You can connect conventional audio equipment and TV.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all
connections are complete.
To connect analog audio component
Be sure that the plugs of the audio cords are color coded:
White plugs and jacks are for left audio signals, and red ones
for right audio signals.
To audio output
Connect the audio output jacks on the other equipment and
AUX IN jacks using an audio cords (not supplied.)
To connect audio equipment with an optical digital
input terminal
You can record CD sound onto the connected digital
equipment.
DIGITAL OUT
[ ]
OPTICAL
To optical
digital input
Audio equipment
with an optical digital
input
Connect an optical digital cord (not supplied) between the
optical digital input terminal on the other equipment and the
DIGITAL OUT [OPTICAL] terminal.
AUX IN
Audio equipment
Protective
plug
Before connecting the
other equipment,
remove the protective
plug from the terminal.
– 8 –
To connect the TV
VIDEO
OUT
TV
Connect the video input jacks and the VIDEO OUT jack on
the rear using a video cord (supplied.)

Adjusting the Voltage Selector

Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
• DO NOT plug in before setting the voltage
selector on the rear of the unit and all connection
procedures are complete.
Using a screw driver, set the voltage selector so that the arrow
on printed on the rear points the correct voltage where you
use this unit. (See the back cover page.)
NOW, you can plug in the unit and other
connected equipment FINALLY!

Cancelling the Display Demonstration

When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
On the unit ONLY:
To cancel the display demonstration, press DEMO.
When you press other buttons
The display demonstration stops temporarily. It will start
automatically again (if no operation is done for 2 minutes) until you
cancel it by pressing DEMO.
To start the display demonstration manually
Press and hold DEMO again for more than 2 seconds.
To video input
R R
220
VOLTAGE
SETTING
220
VOLTAGE
SETTING
CANCEL
/DEMO