Using Recording Timer - JVC CA-MXDVA9R Instructions Manual

Using Recording Timer

With Recording Timer, you can make a tape of a radio
broadcast automatically. You can set the timer whether the
system is on or off.
How Recording Timer actually works
The unit automatically turns on, tunes into the specified
station, sets the volume level to "VOL MIN," and starts
recording when the on-time comes (the
continues flashing while the timer is operating). Then, when
the off-time comes ("OFF" flashes just before the off-time),
the unit automatically turns off (on standby).
The timer setting remains in memory until you change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step 2
again.
• To correct a misentry while setting the timer, press
CANCEL/DEMO.
On the unit ONLY:
1
Put a recordable cassette into deck B.
2
Press CLOCK/TIMER repeatedly
until "REC" appears on the display.
indicator lights up and the REC (Recording
Timer) indicator also starts flashing on the
display.
• Each time you press the button, the timer setting modes
change as follows:
ON TIME
DAILY
(Daily timer setting)
Canceled Clock
setting
(The hour digits
start flashing.)
3
Press CLOCK/TIMER again.
"ON TIME" appears for 2 seconds on the
display, then the unit enters on-time setting
mode.
indicator
REC
ON TIME
(Recording
timer setting)
– 44 –
4
Set the on-time you want the
unit to turn on at.
1) Turn 4 / ¢ to set the hour, then
press SET.
2) Turn 4 / ¢ to set the minute,
then press SET.
"OFF TIME" appears for 2 seconds
on the display, then the unit enters
off-time setting mode.
5
Set the off-time you want the unit to turn off
(on standby) at.
1) Turn 4 / ¢ to set the hour, then press SET.
2) Turn 4 / ¢ to set the minute, then press SET.
The unit enters preset station selecting mode.
6
Select the preset station.
1) Turn 4 / ¢ to select the band ("TUNER FM" or
"TUNER AM"), then press SET.
2) Turn 4 / ¢ to select a preset channel number,
then press SET.
The REC (Recording Timer) indicator stops flashing
and remains lit. The settings you have done are shown
on the display in sequence.
7
Press STANDBY/ON
turn off the unit (on standby)
if necessary.
If you want to listen to another source while recording
Press REC START/STOP or 7 to stop recording. Without stopping
it, you cannot change the source.
Even if you unplug the AC power cord or if a power
failure occurs
Once you set the timer, the timer setting may remain stored in
memory for a few days. In this case, check whether the timer setting
still remains or not.
Continued
to
STANDBY/ON
STANDBY