Turning The Recording Timer On And Off - JVC CA-MD9R Instructions Manual

4
. Select a preset station you want to record.
SET
1. Rotate the MULTI JOG dial to select a preset station.
\
2. Press the SET button to enter the preset station.
MULTI JOG
5.
Select the recording equipment.
The recording equipment changes as follows:
TAPE
MD 1
MULTI JOG
MD 2
MD 3
MD ALL
SET
6.
Press the SET button.
The REC (1 to 3) indicator stops flashing and remains lit. The contents of the Recording Timer
setting are shown on the display fro a while.
7.
Press
STANDBY
A few seconds before the on-time, the CA-MD9R automatically turns on the power, and "REC
(1 to 3) TIMER" flashes on the display. When the on-times comes, recording starts using the
selected recording equipment. When the off-times comes, the power is automatically turned off
again.
Before Turning Off the unit
Check that tape direction is correct when recording on a tape. This is important especially when
the auto reverse mode is off.
Set the auto reverse mode on if you want to record on both sides of the tape.
Check that an MD is inserted in the selected slot(s).
The VOLUME control is automatically set to 0 when Recording Timer starts recording.
To change the recording timer setting
To change the settings for the Recording Timer, repeat the setting procedure from the beginning.
Turning the Recording Timer On and Off ————————————————
Once the Recording Timer has been used to record a source, the setting is maintained but the Timer
is turned off.
To turn the Recording Timer off, press the CLOCK/TIMER button repeatedly until "REC on/off"
appears in the display, then press the CANCEL button. "on" disappears from the display and the
REC indicator goes off.
To turn the Recording Timer on again, press the CLOCK/TIMER button repeatedly until "REC on/
off" appears on the display, then press the SET button. The contents of the Recording Timer settings
are shown on the display for a while.
CAUTION: If the CA-MD9R is unplugged, or a power failure occurs, the timer setting will be erased
in a few days. If the settings are erased in this way, reset the timer settings.
3
CD
2
1
STEREO TUNED
1 2 3 4 5 6 7 8 9
: To record on the tape.
: To record on the MD 1.
: To record on the MD 2.
: To record on the MD 3.
: To record on all the three MDs.
to turn the power off if necessary.
3
MD
2
1
10 11 12 13 14 15 16
REC 1