Getting Ready To Use Dolby Pro Logic; Speaker Arrangements For Dolby Pro Logic; Setting-Up Dolby Pro Logic - JVC CA-D752TR Instructions Manual

Compact component system
Table of Contents

Advertisement

or
PRO LOGIC
SHIFT
\
CENTER MODE
DELAY TIME
TEST TONE
CENTER
+
LEVEL
REAR
+
LEVEL
TEST TONE
16

Getting Ready To Use Dolby Pro Logic

Speaker Arrangements for Dolby Pro Logic ————————
Layout when using the centre speaker and
rear speakers
TV
Front
Speaker
Centre Speaker
Rear
Speaker
Setting-up Dolby Pro Logic ————————————————
1. Press PRO LOGIC/3CH LOGIC to select PRO LOGIC.
Each time you press the button, Dolby Surround programmes change as follows:
= PRO LOGIC = 3CH LOGIC = OFF = (back to the beginning)
When using the Remote Control, press SHIFT then press 1 PRO LOGIC.
Perform the steps below using the buttons on the Remote Control.
2. Select the desired Centre Speaker mode.
Press SHIFT on the Remote Control then press 6 CENTER MODE.
Each time you press the button, Centre Speaker modes change as follows:
= NORMAL = WIDE = OFF = PHANTOM = (back to the beginning)
3. Select the Delay time.
Press 9 DELAY TIME. Each time you press the button, Delay time changes as follows:
= DELAY 2 = DELAY 3 = DELAY 4 = DELAY 1 = (back to the beginning)
4. Set the volume to the level you like.
5. Press 3 TEST TONE.
A test tone comes out of the speakers in the following order:
= LEFT = CENTER = RIGHT = REAR = (back to the beginning)
When a test tone comes out of the rear speakers, "SURROUND" appears on the display.
When "PHANTOM" or "OFF" is selected for Centre Speaker mode, no test tone comes out of the
center speaker.
6. Adjust the level for the centre speaker.
Press CENTER LEVEL 5 + or 4 –. Set the level so that it is about
the same as the level from the front speakers.
You cannot adjust the level for the centre speaker if "PHANTOM" or "OFF" is selected for
Centre Speaker mode.
7. Adjust the level for the rear speakers.
Press REAR LEVEL 8 + or 7 –. Set the level so that it is about
the same as the level from the front speakers.
8. Press 3 TEST TONE again.
Test Tone mode is cancelled.
This completes the preparations required for using Dolby Pro Logic.
Layout when using the rear speakers
Front
Front
Speaker
Speaker
Rear
Rear
Speaker
Speaker
TV
Front
Speaker
Rear
Speaker

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents