Playing Back Tapes; Playing Back A Tape - JVC A-UXP38V Instructions Manual

Playing Back Tapes

You can playback type I, type II, and type IV tapes without
changing any settings.

Playing Back a Tape

1
Press 0 button for cassette deck.
2
Put a cassette in with the exposed part of the
tape down.
3
Close the cassette holder gently.
4
Press TAPE 2 2 2 2 2 3 3 3 3 3 .
The unit automatically turns on and the tape play
starts. The tape direction indicator (3 or 2)
flashes slowly on the display.
• Each time you press the button, the tape
direction changes.
3 3 3 3 3 : plays the front side.
2 2 2 2 2 : plays the reverse side.
When the tape plays to the end, the deck automatically stops
if the reverse mode is set to
— Reverse Mode.")
. (See "To play both sides
– 19 –
To stop playing, press 7.
To fast-wind to the left or to the right, press ¢ NEXT or
PREV 4 button.
The tape direction indicator (3 or 2) starts flashing quickly on
the display.
To remove the cassette, press 0 button for cassette deck.
To play both sides — Reverse Mode
You can set the deck to play just one side of a tape,
both sides once, or both sides continuously.
Press REV.MODE on the unit.
• Each time you press the button, reverse mode
changes as follows:
: The deck automatically stops after playing both
sides of the tape. (Stops when playback in the 2
direction is finished.)
: The deck continues to play both sides of the tape
until 7 is pressed.
: The deck automatically stops after playing one
side of the tape.
The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration may
occur and this tape easily jams in the pinch-rollers
and the capstans.