Connecting Speakers; Connecting Other Equipment - JVC A-UXP38V Instructions Manual

AM antenna
1
2
AM loop antenna
(supplied)
1
Connect the AM loop antenna to the AM LOOP
terminals as illustrated.
• If the AM loop antenna wire is covered with
vinyl, remove the vinyl by twisting it as shown
in the diagram.
2
Turn the AM loop antenna until you have the
best reception.
To connect an outdoor AM antenna
When reception is poor, connect a single vinyl-covered wire to
the AM EXT terminal and extend it horizontally. (The AM loop
antenna must remain connected.)
For better reception of both FM and AM
• Make sure the antenna conductors do not touch any other terminals
and connecting cords.
• Keep the antennas away from metallic parts of the unit, connecting
cords, and the AC power cord.

Connecting Speakers

Vinyl-covered wire
(not supplied)
1
2
3

Connecting Other Equipment

You can connect audio equipment — used only as a playback
device.
– 7 –
Speaker
cord
Right
speaker
Press and hold the clamp of the speaker
terminal on the rear of the unit.
Insert the end of the speaker cord into the
terminal.
Match the polarity of the speaker terminals: Red (+) to red
(+) and black (–) to black (–).
Release the finger from the clamp.
IMPORTANT: Use only speakers with the same speaker
impedance as indicated by the speaker terminals on the rear
of the unit.
• DO NOT connect any equipment while the power
is on.
• DO NOT plug in any equipment until all connections
are complete.
Continued
Red
Speaker
cord
Black
Left
speaker