Goodman AMH8 Service Instructions Manual page 9

PRODUCT IDENTIFICATION
MODEL # MFG #
AFE18-60A
N/A
MODEL # MFG #
P1221001
EFR01
P1221002F
FTK04
FTK04
MODEL # MFG #
HANG20 N/A
HANG21 N/A
HA02
N/A
Fossil Fuel Kit. The AFE18-60A control is d esigned for use where the indo or coil is lo cated
above/d ownstream of a gas or fossil fuel furnace when used with a heat p ump. It will operate
with sing le and two stage heat pumps and single and two stage furna ces. The AFE18-60A
control wi ll turn the he at pump unit off when the furnace is turned on. An anti-short cycle feature
initiates a 3 min ute timed off delay when the compressor goes off.
External Filter Rack Kit . For use with Daikin Brand upflow furnace models. This kit is
intended to provide a location, external to the furnace casing, for installation of a
permanent filter. The rack is mounted over the indoor air blower compartment area of
either side panel, and provide filter retention as well as a location for attaching return air
ductwork.
Furnace Twinning Kit . This kit allows Daikin Brand single stage 80% gas furnaces to
operate at the same time from a single thermostat. The two furnaces to be "twinned" must
be the exact same model with their circulating air blowers set to deliver the same air flow
at the same time. This kit cannot be used to control more than two furnaces.
High Altitude Natural Gas Kit. The kit is designed to convert 80% gas furnace models
fired at 20,000 Btu's per cell for higher altitudes. This kit is required when installing these
furnaces above their maximum rated altitude.
High Altitude Natural Gas Kit. The kit is designed to convert 80% gas furnace models
fired at 20,000 Btu's per cell for higher altitudes. This kit is required when installing these
furnaces above their maximum rated altitude.
High Altitude Kit. The kit is designed to convert Goodman®, Amana® Brand gas furnace
models fired at 22,500 BTU's per cell for higher altitudes. This kit is required when
installing these furnaces above their maximum rated altitude. This kit contains # 43-49, 55-
58 gas orifices. The orifices in the kit have been selected as a result of testing with the
American Gas Association. They will provide appropriate derating at the altitude listed in
the High Altitude Charts as shown in the installation instructions of the kit.
DESCRIPTION
DESCRIPTION
DESCRIPTION
9