Basics Of Using The Cd Player - Normal Play; To Play A Disc; To Select A Disc, Track Or Passage Within A Track; Locating A Track With The Remote Control Directly - JVC /CA-D451TR Instructions Manual

CD
FM
AUX
/AM
TAPE
P. DOWN P. UP
or
DISC
DISC
DISC
1 2 3
CLOCK TIMER PTY/EON
4 5 6
– SELECT +
DISPLAY MODE
7 8 9
SET
10 10
18
Basics of Using the CD Player —
Normal Play
To Play a Disc ———————————————————————
1. Prepare the discs.
2. Press the CD ‹/8 or DISC button (1-3) of the disc you want to play.
When using the Remote Control, press the £/8 button or the DISC (1 to 3) buttons.
The first track of the selected disc will begin playing.
The CD Player automatically stops when the playback finishes the last track of the CD.
• If these buttons are pressed while the tray is open, the tray is automatically closed and playback
starts.
To stop play the disc, press the 7 button (or the 7/CLEAR button on the Remote Control).
To stop play and remove the disc, press the 0 button for the disc being played.
To pause, press the CD ‹/8 button (or the £/8 button on the Remote Control).
To cancel pause, press the CD ‹/8 button again (or press the £/8 button on the Remote Control).
Play continues from the point where it was paused.

To Select a Disc, Track Or Passage Within a Track

1. Press the DISC button (1-3) for the disc tray containing the track
you want to listen to.
• Example: for the third disc, press 3.
2. Press the 4 P.DOWN or ¢ P.UP button to select the track.
The selected track starts playing.
Each time you briefly press and release the 4 P.DOWN or ¢ P.UP button, the track changes by
one.
Press and release the ¢ P.UP button to go ahead one track at a time.
•
Press and release the 4 P.DOWN button to go back one track at a time.
•
Holding down the 4 P.DOWN or ¢ P.UP button, during playback, will fast forward/backwards
the CD so you can quickly find a particular passage in the selection you are listening to.
When using the Remote Control, press the 4 or ¢ button.
Locating a Track With the Remote Control Directly ———
Using the number keys on the Remote Control allows you to go directly to the beginning of any track.
1. Press the DISC button (1-3) for the disc tray containing the track
you want to listen to.
• Example: for the third disc, press 3.
2. Enter the number of the track you want to listen to with the
number keys.
The selected track starts playing.
• Example: for track 5, press 5. For track 15, press +10 then 5. For track 20, press +10, then 10. For
track 32, press +10 three times, then 2.
To Change Discs While Playing ——————————————
You can replace a CD in a tray not being used, while another CD is playing.
1. Press the 0 button of the tray not being used.
The tray opens.
2. Replace the disc in the tray.
3. Press the 0 button to close the tray.
———