2.4.4
Installing Expansion Unit
(KX-TD170 / KX-TD180)
Amphenol 57JE Type (screw-attach-type 50-pin connector) Connection
for KX-TD170
To fix the Amphenol 57JE type (screw-attach type 50-pin
connector) to the g-Station Line Unit, follow the procedures below.
1. The 50-pin connector (Jack) on the
Expansion Unit has two hook-pins.
Remove the upper hook-pin, taking out
the screw.
Screw
connector
Hook-pins
Note
Hook-pin
When connecting a connector of the type
shown below, unscrew the lower hook-pin,
too. Then drive both accessory screws.
Accessory
wire tie
Accessory screw
Amphenol 57JE type
Accessory
Screw
2. To attach the Amphenol 57JE type (Plug) to
the connector, drive the accessory screw at the
upper part.
Fasten the accessory wire tie around the lower
hook-pin and the Amphenol 57JE type, as
shown.
Accessory screw
Amphenol 57E type
Accessory wire tie
2-48
Installation