Panasonic KX-TD816 Installation Manual page 148

3
Features
D
Conditions
transmitted to the CO line.
Call Blocking Mode
Set
this
mode on CO lines that can receive both tone and
rotary. but under contract with the Central Office for rotary
only. When dialing to the line using a touch-tone
telephone, only rotary is sent to the Central Office.
It
is possible for the extension user to temporarily convert the pre-
,
assigned rotary dialing mode to DTMF mode (Pulse to Tone
Conversion). DTMF mode cannot be changed to rotary.
Ether DTMF or rotary dialing can be assigned for the DISA (Direct
Inward System Access)* outgoing line. With DISA*, Pulse to Tone
Conversion is not possible.
In case a CO line can receive both DTMF and pulse signals and is
contracted for DTMF with a Central Office, DTMF mode should be
selected for the line. If it is contracted for rotary mode, Call Blocking
mode should be selected for the line.
If a line is assigned Pulse Dial mode, select an appropriate pulse speed,
pulse break ratio. and inter-digit pause for the line, if needed. If a line
is assigned DTME select an appropriate DTMF duration for the line. if
needed.
After a held call is retrieved, the dial mode goes back to the one
originally programmed on the CO line.
Programming
References
Section 4, System Programming,
14021
[4031
[4041
[9901
Dial Mode Selection
Pulse Speed Selection
DTMF Time
System Additional Information, Fields
(
17). (21)
Feature References
Section 3, Features,
End-to-End DTMF Signaling
(Tone Through)
Pulse to Tone Conversion
Operation References
Not applicable.
-.____
*: Available for KX-TD1232 only.
Features
3-47