Creating Network Access Rules - SonicWALL NSA 2400 Getting Started Manual

Creating Network Access Rules

A Zone is a logical grouping of one or more interfaces designed
to make management, such as the definition and application of
access rules, a simpler and more intuitive process than
following a strict physical interface scheme.
By default, the SonicWALL security appliance's stateful packet
inspection allows all communication from the LAN to the
Internet, and blocks all traffic from the Internet to the LAN. The
following behaviors are defined by the "Default" stateful
inspection packet access rule enabled in the SonicWALL
security appliance:
Originating Zone
LAN, WLAN
DMZ
WAN
WAN and DMZ
Page 36 Creating Network Access Rules
Destination Zone Action
WAN, DMZ Allow
WAN Allow
DMZ Deny
LAN or WLAN
Deny
To create an access rule:
1. On the Firewall > Access Rules page in the matrix view,
select two zones that will be bridged by this new rule.
2. On the Access Rules page, click Add.
The access rules are sorted from the most specific at the
top to the least specific at the bottom of the table. At the
bottom of the table is the Any rule.