Operating The Other Manufacturers' Audio/Video Components - JVC RX-730R Instructions Manual

Operating the Other Manufacturers' Audio/Video Components

Storing the signals
LEARN CANCEL
Remote: Inside
EXT.1
TV VCR EXT.2
CD TAPE
Remote: Inside
Buttons you can assign
signals to
TV VCR
Remote: Outside
+
–
DELAY CENTER
1 2 3 4
– +
REAR
TEST
5 6 7/P 8
FM
MODE/MUTE
9 10 0 +10
PRESET TV
CHANNEL VOLUME
PTY SELECT
PTY SELECT
+
–
PTY SEARCH
TV/VIDEO
TAPE
DISPLAY MODE
Remote: Inside
Page 47
The remote control supplied with the receiver can learn and memorize the signals used for the other
manufactures' remote control unit. By storing these signals, you can operate the other manufacturers' audio/
video components.
Before storing another manufacturer's signals, make sure that manufacturer's remote control unit (hereafter
called "target remote control") actually works.
1 Place the two remote controls on a level surface with signal transmitting windows facing each
other.
Leave a space of 5 to 10 cm (2 to 4 inches) between the two remote controls; otherwise, storing may
be failed.
2 Open the outside panel of this remote control.
3 Press LEARN so that the SEND/LEARN indicator lights up (green).
Lights
4 Press one of the buttons on the remote mode section.
If possible, select the source corresponding to the target remote control's usage.
Lights
Notes:
• Since no signal have been preset for the EXT.1 and EXT.2 modes, you can store signals from the target
remote control without losing any preset signals.
• If you want to store a signal into the TV or VCR button on the POWER section, you can skip this step.
5 Press one of the buttons (illustrated to the left), to which you want to assign a signal from the
target remote control.
The SEND/LEARN indicator starts flashing.
Flashes
Note:
If the ERROR indicator lights red, you have already stored a signal. To change the stored signal, go to
the next step. If you do not want to change it, press another button.
6 While the SEND/LEARN indicator is flashing, press the button on the target remote control,
the signal of which you want to assign to the button of this remote control you have pressed in
step 5.
The SEND/LEARN indicator stops flashing and remains lit, and the ERROR indicator also lights red
but soon goes off.
Lights
Lights
5 to 10 cm
(2 to 4 inches)
SEND/LEARN ERROR
SEND/LEARN ERROR
SEND/LEARN ERROR
SEND/LEARN ERROR
SEND/LEARN ERROR
SEND/LEARN ERROR
SEND/LEARN ERROR
SEND/LEARN ERROR
Lights