JVC RX-730R Instructions Manual page 38

Front panel
Front panel
Front panel
Page 33
6. Press Control % % % % % / fi fi fi fi fi until "–DELAY +" appears on the display.
7. Press Control @ @ @ @ @ / # # # # # to adjust the delay time of the rear speaker output.
Each time you press the button, the delay time changes as follows:
DELAY 1
DELAY 4
DELAY 1 Select this when the distance from you to your rear speakers is greater than that
to the front speakers.
DELAY 2 Select this when the distance from you to your rear speakers is almost equal to
that to the front speakers.
DELAY 3 Select this when the distance from you to your rear speakers is a little less than
that to the front speakers.
DELAY 4 Select this when the distance from you to your rear speakers is much less than
that to the front speakers.
Note:
When you have selected "3CHLOGIC," you cannot adjust the delay time.
8. Press Control % % % % % / fi fi fi fi fi until "TEST" appears on the display, then press Control @ @ @ @ @ / # # # # # to start
checking the speaker output balance.
"TEST" starts flashing on the display, and a test tone comes out of the speakers in the following
order:
Left front speaker
Notes:
• No test tone comes out of the rear speakers when you have selected "3CHLOGIC."
• No test tone comes out of the center speaker when you select "PHANTOM" or "OFF" for the center
mode.
9. If necessary, adjust the speaker output level as follows:
• To adjust the rear speaker output level, press Control % / fi until "– REAR +" appears on the
display, then press Control @ / #.
• To adjust the center speaker output level, press Control % / fi until "–CENTER+" appears on the
display, then press Control @ / #.
Notes:
• You cannot adjust the left and right rear speaker output level separately.
• You cannot adjust the rear speaker output level when you have selected "3CHLOGIC."
• You cannot adjust the center speaker output level when you select "PHANTOM" or "OFF" for the
center mode.
DELAY 2
DELAY 3
Right front speaker
Center speaker
Rear speakers