JVC MX-G70 Service Manual page 7

Removing the CD changer mechanism
assembly (See Fig.4 and 5)
Prior to performing the following procedure, remove
the metal cover.
1. Disconnect the card wire from connector CN661 on
the Main board.
2. Remove the two screws C on the upper side of the
body and the two screws D on the back of the rear
panel.
3. Remove the plastic rivet attaching the main board.
4. Remove the fan connector CN705.
5. Pull both the rear panel and the front panel assembly
to the outside, then remove the CD changer
mechanism assembly by lifting the rear part of the
assembly.
CAUTION: To prevent damage to the CD fitting, be
sure to pull both the rear panel and the
front panel assembly enough to remove
the CD changer mechanism assembly.
Removing the front panel assembly
Prior to performing the following procedure, remove
the metal cover and CD changer mechanism
assembly.
1. Disconnect the card wires from connector CN870,
CN871 and CN315 on the main board respectively.
2. Remove the tie band and disconnect the wire from
connector CN703 on the amplifier board.
3. Disconnect the wire from connector CN220 on the
transformer board.
CD changer mechanism assembly
Front panel assembly
(See Fig.6 to 10)
Front panel assembly
Front panel assembly
C
Main board
CN661
Fig.4
Main board
CN661
Plastic rivet
Fig.5
Tie band
Amplifier board
CN703
Fig.6
Fig.7
MX-G70
C
CD changer
mechanism assembly
Rear panel
Rear panel
D
Main board
CN870
CN871
CN315
Front panel
assembly
Transformer board
CN220
Main board
1-7