Connecting Audio/Video Components - JVC RX-1024VBK Instructions Manual

Connecting Audio/Video Components

You can connect the following audio/video components to this receiver. Refer also to the
manuals supplied with your components. If you want to connect a component not listed
in the table below, refer to the manual supplied with it.
Audio Components
• Turntable
• CD player*
• Cassette deck or MD recorder* • DBS tuner*
* You can connect these components using the methods described in "Analog
connections" (below) or in "Digital connections" (see page 11).
Analog connections
Audio component connections
Use the cables with RCA pin plugs (not supplied).
Connect the white plug to the audio left jack, and the red plug to the audio right jack.
To audio output
Turntable
If an earth cable is provided for your
turntable, connect the cable to the
screw marked GND on the rear panel.
CD player
Cassette deck
or
MD recorder
If your audio components have a COMPU LINK-3 or TEXT COMPU
LINK terminal
• See also page 48 for detailed information about the connection and the COMPU
LINK-3 remote control system.
• See also page 49 for detailed information about the connection and the TEXT
COMPU LINK remote control system.
Video Components
• DVD player*
• TV
• VCRs
• Video camera
GND
To audio output
To audio input
To audio output
To audio output
To audio input
AUDIO
RIGHT LEFT
PHONO
CD
OUT
(REC)
TAPE
/MD
IN
(PLAY)
CAUTION:
If you connect a sound-
enhancing device such as a
graphic equalizer between the
source components and this
receiver, the sound output
through this receiver may be
distorted.
Notes:
• Any turntables incorporating
a small-output cartridge such
as an MC (moving-coil type)
must be connected to this
receiver through a
commercial head amplifier or
step-up transformer. Direct
connection may result in
insufficient volume.
• You can connect either a
cassette deck or an MD
recorder to the TAPE/MD
jacks. When connecting an
MD recorder to the TAPE/MD
jacks, change the source
name, which will be shown on
the display when selected as
the source, to "MD." See page
17 for details.
8