Connecting Audio/Video Components; Analog Connections - JVC RX-8030VBK Instructions For Use Manual

Enhancing your audio system
—Only for RX-8030VBK
You can use this receiver as the pre-amplifier (control amplifier)
when you connect power amplifiers to the PREOUT jacks on the
rear using cables with RCA pin plugs (not supplied).
• Connect the white plug to the audio left jack, and the red plug to
the audio right jack.
RX-8030VBK
Left front speaker
Power amplifier
Power amplifier
PREOUT
SURR BACK SURR
L
R
SUBWOOFER
Power amplifier
Power amplifier
Left surround
speaker
Surround back speakers
Left / Right
Note:
If you connect one surround back speaker, connect the surround back
speaker to the left surround back PREOUT jack (SURR BACK L).
RX-8030V
ONLY
Right front speaker
Center speaker
CENTER FRONT
L
R
L
R
L
R
Right surround
speaker

Connecting Audio/Video Components

When connecting individual components, refer also to the manuals
supplied with them.

Analog Connections

If your audio components have digital audio output terminal,
connecting them using the digital cords explained in "Digital
Connections" (see page 16) will give you better sound quality.
Audio component connections
Use the cables with RCA pin plugs (not supplied).
• Connect the white plug to the audio left jack, and the red plug to
the audio right jack.
If your audio components have a COMPU LINK jack
See also page 41 for detailed information about the connection
and the COMPU LINK remote control system.
CAUTION:
If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this receiver, the sound output
through this receiver may be distorted.
Turntable
To listen to the sound after connection, press PHONO.
RX-8030VBK
Turntable
To audio output
Note:
This connection is for the turntable with an MM (moving-magnet) type
cartridge.
Any turntables incorporating a small-output cartridge such as an MC
(moving-coil) type must be connected to this receiver through a
commercial head amplifier or step-up transformer. Direct connection
may result in insufficient volume.
RX-8030V
ONLY
R
PHONO
IN
L
RIGHT LEFT
If a ground cable is
provided for your turntable,
connect the cable to the
screw marked (H) on the
rear.
11