Using The Dvd Multi Playback Mode; Activating The Dvd Multi Playback Mode - JVC LVT0178-001A Instructions Manual

Audio/video control receiver
Table of Contents

Advertisement

Using the DVD MULTI Playback Mode

This receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DVD
player. Before playing back a DVD, refer also to the manual supplied with the DVD player.
IMPORTANT:
When using the remote control, check to see if its
remote control mode selector is set to the correct
position:
To operate this receiver, set it to "AUDIO/TV/
VCR" (except when selecting the DBS tuner as
the source).

Activating the DVD MULTI Playback Mode

You can adjust the DVD MULTI playback mode while playing back
a DVD using the analog discrete output mode on the DVD player.
Once you made adjustments, the receiver memorizes the
adjustments until you change them. You also need to set the DVD
player to the analog discrete output mode.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel:
1. Turn SOURCE SELECTOR until
"DVD MULTI" appears on the
display.
Note:
When you select "DVD MULTI" as the source to play, the DSP
mode is canceled temporarily, and the DOLBY/DTS/MPEG
SURROUND ON/OFF and DSP MODE buttons do not work.
2. Select the analog discrete output mode on the
DVD player, and start playing a DVD.
• Refer to the manual supplied with the DVD player.
If you need to make any adjustment, go to the following
steps.
3. Adjust the speaker output levels.
1) Press BALANCE/SURROUND
ADJUST repeatedly until one of the
indications appears on the display.
"CENTER LEVEL":
To adjust the center speaker level.
"REAR L LEVEL":
To adjust the left rear speaker level.
"REAR R LEVEL":
To adjust the right rear speaker level.
2) Turn MULTI JOG to adjust the
selected speaker output level (from –10
dB to +10 dB).
3) Repeat 1) and 2) to adjust the other
speaker output levels.
29
4. Adjust the center tone.
1) Press BALANCE/SURROUND
ADJUST repeatedly until "CENTER
AUDIO/
TV/VCR
TONE" appears on the display.
The display changes to show the current
CATV/DBS
setting.
2) Turn MULTI JOG to select the center
tone level you want.
The center tone adjustment affects the
mid-frequency range, which the human
voice is mostly made up of.
• As you turn it, the display changes to
Adjusted levels are also shown on the equalizer display.
S E A
100
SOURCE SELECTOR
To make the dialogue clearer, select "SHARP 1" (little) or
"SHARP 2" (much).
To make the dialogue softer, select "SOFT 1" (little) or "SOFT
2" (much).
When "FLAT" is selected, no adjustment is applied.
BALANCE/SURROUND
ADJUST
MULTI JOG
show the following:
SOFT 2
SOFT 1
FLAT
This CNTR means this adjustment can
be applied to the center speaker only.
CNTR
(Example: When "FLAT" is selected.)
1k
10k
BALANCE/SURROUND
ADJUST
MULTI JOG
SHARP 1
SHARP 2

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Rx-889pRx-889pgd

Table of Contents