Receiving Radio Broadcasts; Tuning In Stations Manually; Using Preset Tuning - JVC LVT0178-001A Instructions Manual

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.
IMPORTANT:
When using the remote control, check to see if its
remote control mode selector is set to the correct
position:
To operate this receiver, set it to "AUDIO/TV/
VCR" (except when selecting the DBS tuner as
the source).

Tuning in Stations Manually

Check the AM tuner internal spacing (9 kHz or 10 kHz) for your
area. (See page 16.)
On the front panel:
1. Turn SOURCE SELECTOR to
select the band (FM or AM).
The last received station of the selected band
is tuned in.
100 1k 10k
2. Press FM/AM TUNING.
3. Turn MULTI JOG until you find
the frequency you want.
• Turning it clockwise increases the
frequency.
• Turning it counterclockwise decreases the
frequency.
• When you turn MULTI JOG quickly, the
frequency keeps changing until a station is
tuned in.
From the remote control:
1. Press FM/AM to select the band.
• Each time you press the button, the band
alternates between FM and AM.
2. Press TUNING UP or TUNING
DOWN repeatedly until you find
the frequency you want.
• When you hold the button, the frequency
keeps changing until a station is tuned in.
Note:
When a station of sufficient signal strength is tuned in, the TUNED
indicator lights up on the display.
When an FM stereo program is received, the STEREO indicator also
lights up.
17

Using Preset Tuning

AUDIO/
Once a station is assigned to a channel number, the station can be
TV/VCR
quickly tuned. You can preset up to 30 FM and 15 AM stations.
CATV/DBS
To store the preset stations
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
On the front panel ONLY:
1. Tune in the station you want to preset (see
"Tuning in Stations Manually").
• If you want to store the FM reception mode for this station,
SOURCE SELECTOR
EON
TA
NEWS
INFO
VOLUME
2. Press TUNER/SEA MEMORY.
FM/AM TUNING
MULTI JOG
"CH-" appears and the channel number position starts flashing
on the display for about 10 seconds.
3. Turn MULTI JOG to select a
channel number while the channel
number position is flashing.
Note:
FM/AM
You can use the 10 keys on the remote control to select the preset
number. When using the 10 keys, be sure that they are activated
for the tuner, not for the CD and others. (See page 42.)
4. Press TUNER/SEA MEMORY
FF/
again while the selected channel
TUNING UP
number is flashing on the display.
/REW
The selected channel number stops flashing.
DOWN TUNING
The station is assigned to the selected channel number.
5. Repeat steps 1 to 4 until you store all the stations
you want.
To erase a stored preset station
Storing a new station on a used number erases the previously stored
one.
select the FM reception mode you want. See "Selecting the
FM Reception Mode" on page 18.
100 1k 10k
CH–
100 1k 10k
CH–
100 1k 10k
EON
TA
NEWS
INFO
VOLUME
TUNER/SEA MEMORY
EON
TA
NEWS
INFO
VOLUME
MULTI JOG
TUNER/SEA MEMORY
EON
TA
NEWS
INFO
VOLUME