Receiving Radio Broadcasts; Tuning In To Stations Manually - JVC RX-8040B Instructions Manual

Receiving Radio Broadcasts

You can browse through all the stations or use the preset function to go immediately to a particular station.
Indicates the functions YOU CAN ALSO USE when
the receiver is ready for Zone 2 operations.
IMPORTANT:
Check the following before or while using the buttons and controls.
For Zone 1 operations:
The ZONE 1 indicator lights up on the unit's display.
For Zone 2 operations:
The ZONE 2 indicator lights up on the unit's display.
• When using the unit:
– For Zone 1 operations: "ZONE2" is not shown in the unit's main
display.
– For Zone 2 operations: "ZONE2" is shown in the unit's main
display.
• When using the remote control:
When operating the receiver using the remote control, the
unit's display always shows the Zone 1 source information
though you are operating it for the Zone 2 source.
– Set the ZONE 1/ZONE 2 selector to ZONE 1 or ZONE 2 correctly.
– Check the indication shown on the remote's display when you
press a button—this indicates the remote control operation mode
together with multi-room operation mode (either for ZONE 1 or
ZONE 2) for about two hours.
ZONE 1 ZONE 2
AUDIO POWER
STANDBY ON
ZONE 1 ZONE 2
ZONE 1 ZONE 2 TV/CATV/DBS DVD
POWER POWER
ON/OFF ON/OFF
ZONE 1
Ex. When you press FM or AM
with ZONE 1/ZONE 2
selector set to ZONE 1.
30
ZONE 1 ZONE 2
AUDIO POWER
STANDBY ON
ZONE 1 ZONE 2
ZONE 1 ZONE 2 TV/CATV/DBS DVD
POWER POWER
ON/OFF ON/OFF
ZONE 2
Ex. When you press FM or AM
with ZONE 1/ZONE 2
selector set to ZONE 2.

Tuning in to Stations Manually

/ REW
DOWN
1. Press FM or AM to select the band.
The last received station of the selected band is tuned in.
When operating for Zone 1
ANALOG
L R LINEAR PCM
When operating for Zone 2
LINEAR PCM
2. Tuning in to the frequency.
On the front panel:
Pressing FM/AM TUNING 5 increases the frequency.
Pressing FM/AM TUNING ∞ decreases the frequency.
On the remote control:
Pressing TUNING UP increases the frequency.
Pressing TUNING DOWN decreases the frequency.
Notes:
• When a station of sufficient signal strength is tuned in, the TUNED
indicator lights up on the unit's display.
• When an FM stereo program is received, the STEREO indicator
also lights up on the unit's display.
• When you hold the button (and release it) in step 2 , the frequency
keeps changing until a station is tuned in.
• You can only select the same station of the same band (FM or AM)
for both Zone 1 and Zone 2 operations. If you change the station for
Zone 2, it also changes for Zone 1 (and vice versa: indications on the
unit's display also change). This also means that if you change the
station for Zone 2 while recording a broadcasting program in Zone 1,
recording in Zone 1 will be interrupted.
FM AM
FF/
TUNING UP
TUNED STEREO AUTO MUTING
SPEAKERS 1 ZONE 2
VOLUME
ZONE 1
ZONE 2
TUNED STEREO AUTO MUTING
SPEAKERS 1 ZONE 2
VOLUME
ZONE 1
ZONE 2