Trunk Naming - AT&T Synapse Installation Manual

Trunk Naming

You can name the system trunks for easier identification. For PSTN Gateways, you can assign names to all lines—up to 16,
depending how many PSTN Gateways are installed. For the T1 Gateway, there is only one physical trunk, so only that one trunk
can be named regardless of how many slots the T1 trunk supports.
Renaming Gateway trunks is highly recommended in Line Appearance mode and when reserving trunks. See
(Outgoing Calls)" on page
To name a trunk:

Figure 117. Trunk Naming
System Configuration
Synapse Installation Guide
107.
1. In the Navigation Menu at left, click System
Settings, then Trunk Naming. The page shown in
Figure 117 appears.
2. Select a Trunk to Change from the drop-down list.
All trunks are listed.
3. Enter the New Trunk Name using up to 16
characters. In Line Appearance mode, trunk names
appear on SB67030 Deskset screen. Because of space
requirements on the screen and varying character
widths, limiting trunk names to four to six characters
is recommended.
4. Click to save the entry or click
refresh the page without saving the changes.
106
"Trunk Reservation
to