Basic Operations; Turn On The Power; Select The Source To Play - JVC 1105RYMMDWJEIN Instructions Manual

Basic operations

1
Source lamps
1
4
7
10
1

Turn on the power

Press STANDBY/ON (or
remote control).
The standby lamp goes off and the source lamp of the current
source lights in red.
Current source name appears.
ANALOG AUTO SURR
L R
S.WFR
To turn off the power (into standby)
Press STANDBY/ON (or
again.
The standby lamp lights in red.
NOTES
• A small amount of power is consumed in standby mode. To turn
the power off completely, unplug the AC power cord.
• Turning a source component on before turning the receiver on
may cause a noise or interrupt the sound and picture. In this
case, turn both the source component and the receiver off, then
turn the receiver on before turning the source component on.
3
2
1
2
3
2 3
5 6
8 9
0 10
AUDIO on the
TUNED STEREO AUTO MUTING
MHz
AUDIO on the remote control)
2

Select the source to play

On the front panel:
Turn SOURCE SELECTOR until the source name
you want appears on the display.
The source lamp corresponding to the selected source lights in
red.
• As you turn SOURCE SELECTOR, the source changes as
follows:
ANALOG
AUTO SURR TUNED STEREO AUTO MUTING
L R
S.WFR
DVR/DVD VCR
USB WIRELESS
FM AM AUX
(Back to the beginning)
DVR/DVD: Select this for the DVD recorder or DVD
player.
VCR: Select this for the VCR.
VIDEO: Select this for the component connected
to the VIDEO IN jacks on the rear of the
receiver.
TV: Select this for the TV.
USB WIRELESS: Select this for the PC component using
a wireless equipment.
USB TERMINAL: Select this for the PC component.
FM: Select this for an FM broadcast.
AM: Select this for an AM (MW) broadcast.
AUX: Select this for the component connected
to the AUX jacks on the front panel
(inside the front door).
From the remote control:
Press one of the source selecting buttons.
• For "USB WIRELESS" and "USB TERMINAL," press USB. Each
time you press USB, the mode alternates between "USB
WIRELESS" and "USB TERMINAL."
• For "FM" and "AM," press FM/AM. Each time you press FM/AM,
the mode alternates between "FM" and "AM."
NOTE
When connecting a video component to HDMI VIDEO (VCR) IN
terminal or COMPONENT VIDEO (VCR) IN jacks, "VCR" and
"VIDEO" are assigned for the source you have selected in "HDMI
SELECT" and "CMPNT SELECT" (see page 32).
MHz
VIDEO TV
USB TERMINAL
19