Philips Q552.2L Service Manual page 15

4.2 Service Positions
For easy servicing of a TV set, the set should be put face down
on a soft flat surface, foam buffers or other specific workshop
tools. Ensure that a stable situation is created to perform
measurements and alignments. When using foam bars take
care that these always support the cabinet and never only the
display. Caution: Failure to follow these guidelines can
seriously damage the display!
Ensure that ESD safe measures are taken.
4.3 Assy/Panel Removal Blockbuster/Emmy
Styling (xxPFL6/7xxx/xx series)
For the 40" and 46" sets, additional instructions (rear cover
removal) apply. Refer to subsection
and 46" sets.
The instructions apply to the 37PFL6606H/12 (Blockbuster -
European model) - without Ambilight. At time of publishing of
this manual, no data was available for the Ambilight models
(series xxPFL7606D/xx - Emmy).
4.3.1 Rear Cover
Warning: Disconnect the mains power cord before you remove
the rear cover.
Mechanical Instructions
Figure 4-7 Cable dressing 47PFL8606D/7x (Sundance)
Additional instructions 40"
back to
div. table
Q552.2L LA
Note: it is not necessary to remove the stand while removing
the rear cover.
1. Remove all screws of the rear cover.
2. Lift the rear cover from the TV. Make sure that wires and
flat coils are not damaged while lifting the rear cover from
the set.
Additional instructions 40" and 46" sets
40"and 46" sets have a dedicated method to open the bottom
catches when removing the rear cover.
Refer to Figure 4-8 and Figure 4-9
1
Figure 4-8 Bottom catches 40" and 46" sets -1-
4. EN 15
19112_101_110712.eps
110712
for details.
1
19100_048_110216.eps
110216
2011-Jul-15