Connecting Md Recorder Xm-G6; Connecting Sub Woofer System; Connecting Antennas - JVC UX-G66R Instructions Manual

Continued

Connecting MD Recorder XM-G6

You can also connect the MD recorder XM-G6 (not
supplied), specifically designed for UX-G66R. This unit will
complete UX-G66R micro component system.
When you connect and use this unit, refer to the Instructions
supplied with it for details.
AX-UXG66
XT-UXG66R
FROM CONNECTOR-C
XM-G6
TO CONNECTOR-C
• DO NOT install XM-G6 until you turn off the
system and unplug the AC power code, otherwise
installation should fail to damage the system.
• DO NOT change the vertical stacking order of XM-
G6 as illustrated to avoid heat buildup.

Connecting Sub Woofer System

When using JVC external sub woofer system, connect
audio cable between AX-UXG66's SUB WOOFER OUT
jack and the input of your sub woofer system.
SUBWOOFER OUT
AX-UXG66
AX-UXG6
Audio cable
(not supplied)
7

Connecting Antennas

Supplied FM antenna
External wire
(supplied with XM-G6)
External wire
(supplied with UX-G66R)
1
2
3
Optical digital cable
(supplied with XM-G6)
To connect an outdoor FM antenna
Before connecting it, disconnect the supplied FM antenna.
Sub Woofer System
(not supplied)
F M
C O
7 5
A X
I A
L
Attach the FM antenna to the FM 75
terminal on the rear panel of XT-UXG66R.
Extend the FM antenna.
Fasten it up in the position which gives you the
best reception.
About the supplied FM antenna
The FM antenna supplied with this unit can only be
used as temporary measure. If reception is poor,
you can connect an outdoor FM antenna.
Outdoor FM antenna
(not supplied)
F M
C O
7 5
A X
I A
L
A 75 antenna with coaxial type connector
(DIN 45325) should be used.
A M
L O
O P
COAXIAL
A M
L O
O P