JVC SR-V10U Instructions Manual page 45

You can use a camcorder as the playback VCR and your
VCR as the recording VCR
1
Make connections
Connect an audio/video cable between the
camcorder's audio/video output connectors and
your VCR's audio/video input connectors.
When using a camcorder with a monaural
output, connect the audio output connector on
the camcorder to the left audio input connector
on this VCR.
2
Load a cassette
Insert the cassette to be recorded on into this
VCR (for recording).
3
Select input mode on this VCR
Select "L-1" — when connecting the camcorder
Select "F-1" — when connecting the camcorder
On the front panel:
Push the JOG dial, then turn it to the left or right.
On the Remote:
Press the Number key "0 (AUX)" and/or CH +/–.
4
Select video input terminal
Follow the procedure described on pages 37 and
40.
When using S VIDEO terminal, set "FRONT AUX
INPUT" (or "REAR AUX INPUT" if you use the
connectors on the rear) to "S-VIDEO".
When using VIDEO terminal, set "FRONT AUX
INPUT" (or "REAR AUX INPUT") to "VIDEO".
5
Select edit mode
Follow the procedure described on pages 37 and
38.
to the audio/video input
connectors on the rear panel.
to the audio/video input
connectors on the front panel.
6
Return to normal screen
Press MENU.
7
Start playback
Set the camcorder to its play mode.
NOTE:
If the camcorder is equipped with a superimpose/OSD
disable feature then set it to "OFF" before starting
playback.
8
Start recording
On the front panel:
Press REC ( ¶ ).
On the Remote:
Press REC ( ¶ ) and PLAY ( 3 ) at the same time.
NOTE:
Be sure to select "AUTO" for "PICTURE CONTROL" (or
"NORM" when "VIDEO CALIBRATION" is set to "OFF") after
you finish dubbing the tapes (
45
EN
pg. 37 and 38).