Gps Setup - Simrad RS90 Operating Manual

16
Hi
DSC
DSC
MENU SELECT
PRI
BUDDY LIST
LOCAL/DIST
CONTRAST
GPS/DATA
USA
16
Hi
DSC
GPS/DATA
PRI
MANUAL
SETTING
GPS SOURCE
USA
16
Hi
DSC
RESTRICTED
PRI
12:28 LOC
A
M27 56.020 N
082 50.190 W
USA
94 |

GPS setup

If a GPS receiver is connected to the NMEA port of the RS90, the
radio will automatically receive the vessel's position and local time
from the GPS.
If GPS data is not available for some reason, the radio will sound the
NO GPS alert for 2 minutes (or until you press any key).
If the GPS data becomes older than 4 hours, the NO GPS alert will
sound, and it can only be silenced manually or by the reception or
manual entry of new GPS data.
If the vessel's GPS data is older than 23.5 hours, the data will be
erased and the NO GPS alert will sound.
Manually entering position and UTC time
¼ Note:
this function is only shown when there is no GPS receiver
connected.
Select MENU → GPS/DATA → MANUAL.
1.
2.
Enter the latitude, then the longitude, then the UTC.
When you have finished, the latitude, longitude and UTC time will
be shown on the standby screen. The prefix M indicates a manual
entry.
¼ Notes
•
Manual entries are cancelled if a real GPS position is received.
•
A warning will be displayed after 4 hours to remind you that the
current position information was manually entered.
Setup | RS90 Operating Manual