5
¼ Note:
16
Hi
DSC
C
MENU SELECT
PRI
WAYPOINT
N2K DATA
VOICE REC
BACKLIGHT
USA
16
Hi
DSC
C
WAYPOINT
PRI
WP LIST
NEAREST WP
USA
16
Hi
DSC
C
WP LIST
PRI
NEW WP
USA
¼ Note
16
Lo
Hi
DSC
C
SAVE
PRI
YES
NO
USA
Waypoint procedures
A waypoint refers to the latitude, longitude and name of a place that
you have entered into the radio. A waypoint can be a destination, a
point along a planned course, or any location useful for navigation,
such as a fishing spot.
You can use waypoints as follows:
•
Display the coordinates, bearing and distance to a waypoint on
the standby screen. See "Navigating to a waypoint" on page
43.
•
Output a waypoint's coordinates and other details via NMEA
2000 for display on a chart plotter or other compatible device.
See "Sending waypoint data to a chart plotter" on page 44.
The RS90 can store up to 200 waypoints.
Adding a new waypoint
Select MENU → WAYPOINT → WP LIST.
1.
Your waypoint list will be displayed.
2.
Press [OK].
NEW WP starts to flash.
3.
Press [OK] again to add a new waypoint.
4.
Enter a waypoint name (maximum 6 characters).
5.
Enter the latitude. Use ▲ or ▼ key to select N or S as required, and
then press [OK] to move to the longitude setting.
6.
Enter the longitude. Press [OK] once you have selected E or W.
7.
When prompted, select YES or NO to save the new waypoint.
When the waypoint list is full, you must delete an entry before you
can create a new entry.
Waypoint procedures |
RS90 Operating Manual
| 41