Menus And Options Overview; Table F-3. Main Front Panel Menu With Asynchronous Overhead (With Aupc; Table F-4. Select Configuration Modulator Menu (With Aupc - Comtech EF Data SDM-650B Installation And Operation Manual

SDM-650B Satellite Modem
F.5.1 Menus and Options Overview
Refer to Section F.5.2 for menu and option explanations.
Note: The "A" after the software version designates "Asynchronous."

Table F-3. Main Front Panel Menu with Asynchronous Overhead (with AUPC)

Screen
SDM650 "TYPE"
SW_4.12A
SELECT CONFIG
SELECT MONITOR
SELECT FAULTS
SELECT StFAULTS
SELECT REMOTE
SELECT UTILITY

Table F-4. Select Configuration Modulator Menu (with AUPC)

Menus
TX-x Code_Rate
TX_Freq
RF_Out
TX_Power
or
AUPC_PWR
DifEncdr
Scramblr
CW_Mode
Rev. 5
Submenus/Options
MOD
DEMOD
INTRFACE
AUPC
Submenus/Options
x = A, B, C, D, or V
50.000 to 90.000 MHz or 100.000 to
180.000 MHz
ON
OFF
-5.0 dBm to -30 dBm
ON
OFF
ON
OFF
Center
Dual
Offset
Asynchronous Overhead Channel Unit
Comments
This is an information-only screen.
The "A" on line 2 means the
asynchronous option is installed.
Go to Table F-4.
Go to Table F-5.
Go to Table F-6.
Go to Table F-7.
Go to Table F-8.
Go to Table F-9.
Go to Table F-10.
Go to Table F-11.
Go to Table F-12.
Comments
In 2.5 kHz steps.
In 0.5 dBm steps.
When AUPC is turned ON in the
AUPC configuration menu, this
window will display AUPC_PWR.
F–13