Jam Inside Printer - Samsung CLP-600 Series Service Manual

6.2.5 Jam Inside Printer

If paper is jammed inside the printer, a lamp turns on at the corresponding location on the Status map. If
you use the CLP-600N, "Jam Inside Printer" also appears on the display.
1. Using the handle, completely open the access
door.
2. Open the top cover.
3. Holding the inner cover open, carefully take the
jammed paper out of the printer. The inner
cover will then close automatically.
The fuser
is hot!
Samsung Electronics
CAUTION:
• Do not touch the fuser inside the inner cover. It
is hot and could cause burns! The fuser's operating
temperature is 180°C (356°F). Take care when
removing paper from the printer.
• Do not touch the green surface, the OPC drum,
on the front of each toner cartridge with your
hands or any other material. Use the handle on
each cartridge in order to avoid touching this
area.
• Be careful not to scratch the surface of the paper
transfer belt.
• If you leave the access door open for more than
a few minutes, the OPC drum can be exposed to
light. This will cause damage to the OPC drum.
Close the access door should the installation
need to be halted for any reason.
4. After removing the jammed paper, check for
paper which may be jammed in other parts of
the printer.
5. After making sure that the access door is open,
close the top cover. Make sure that it is securely
latched.
6. Close the access door firmly. The printer will
resume printing.
CAUTION:
• If the top cover and access door are not
completely closed, the printer will not operate.
Alignment and Adjustmens
Service Manual
6-7