Authorisation; Specifications - Gigaset C450 IP User Manual

Authorisation

This device is intended for analogue
phone lines in your network.
Voice over IP telephony is possible with an
additional modem via the LAN interface.
Country-specific requirements have been
taken into consideration. We, Siemens
Home and Office Communication Devices
GmbH & Co. KG, declare that this device
meets the essential requirements and
other relevant regulations laid down in
Directive 1999/5/EC.
A copy of all international 1999/5/EC Dec-
larations of Conformity is available at:
http://www.siemens.com/gigasetdocs

Specifications

Recommended rechargeable batteries
(Valid at the time of going to press)
Nickel-metal-hydride (NiMH):
u
Sanyo Twicell 650
u
Sanyo Twicell 700
u
Sanyo NiMH 800
u
Panasonic 700 mAh "for DECT"
u
GP 550mAh
u
GP 700mAh
u
GP 850mAh
u
Yuasa Technology AAA Phone 600
u
Yuasa Technology AAA Phone 700
u
Yuasa Technology AAA 800
u
VARTA Phone Power AAA 700mAh
The handset is supplied with two recom-
mended batteries.
Handset operating times/charging
times
The following information relates to bat-
teries with a capacity of 650 mAh.
Standby time around 125 hours (5 days)
Talktime around 13 hours
Charging time around 7.5 hours
The operating and charging times apply
only when using the recommended bat-
teries.
Base station power consumption
Depending on current status,
around 2.5 W.
General specifications
Interfaces Fixed network, Ethernet
DECT standard is supported
GAP standard is supported
No. of channels 60 duplex channels
Radio frequency 1880–1900 MHz
range
Duplex method Time multiplex,
10 ms frame length
Channel grid 1728 kHz
Bit rate 1152 kbit/s
Modulation GFSK
Language code 32 kbit/s
Transmission 10 mW,
power average power per chan-
nel
Range up to 300 m outdoors,
up to 50 m indoors
Base station 230 V ~/50 Hz
power supply
Environmental +5 °C to +45 °C;
conditions for
20 % to 75 % relative
operation
humidity
Dialling mode DTMF (touch tone dial-
ling)/DP (dial pulsing)
Flashing time 250 ms
Appendix
57