Basic Settings With The Subdisplay; Basic Operations In The Subdisplay - Sony SRW-9000PL Operation Manual

Basic Settings with the
Subdisplay
On the unit, you can easily make basic settings for
the camera module by using the subdisplay
located on the side of the unit or the optional AP-
1 Assistant Panel connected via the CTRL
(CAM) connector.
Basic Operations in the
Subdisplay
Use the buttons and dials shown in the figures
below for subdisplay operations.
Right side of the unit (display/menu operations
section)
VF MENU/
DISPLAY button
(confirm a setting)
PAGE button
(advance to the
Press (confirm a setting)
next page or
MENU SEL/ENTER dial
confirm a
setting)
a) Turning the dial changes a setting, and pressing it
confirms a setting (ENTER button function).
Note
When you turn the dial, stop it at a position where you
feel a click. If you force the dial to stop at a non-click
position, the operating stability of the dial on the AP-1
side may be affected.
44

Basic Settings with the Subdisplay

CANCEL/STATUS button
(cancel a setting)
SET button (return
to a page or enter
data modification
mode by pressing
for one second)
Turn (change a
setting)
a)
AP-1 Assistant Panel
CANCEL/STATUS button
VF MENU/
DISPLAY button
LOCK switch
PAGE button
RUN button SET button
a) Turning the dial changes a setting, and pressing it
confirms a setting (ENTER button function).
You can also use the display/menu operations
section of the main unit to operate the subdisplay
of the AP-1, and use the AP-1 to operate the
subdisplay on the right-side panel.
However, the LOCK switches function
independently. When you want to lock the
display/menu operations section or the AP-1, turn
on the LOCK switch on that side.
To display setting pages
After the unit is turned on, the current operation
mode (CINE, CINE-EI or CUSTOM) appears on
the subdisplay for several seconds, followed by
the most recently used settings page.
To advance one page
Press the PAGE button.
To go back one page
Press the SET button (press and release the button
within one second).
To change a setting
1
Press and hold the SET button for more
than 1 second.
The unit enters data modification mode, the
cursor ( | ) starts flashing, and a question
mark appears at the rightmost position on the
first line.
MENU SEL/
a)
ENTER dial
Press
Turn