Sony SRW-9000PL Operation Manual page 191

warning message code appears in the operation
status and warnings section of the control panel
display (see page 26). This section is visible when
the display is showing the HOME screen.
Note
Warning messages do not appear unless the display is
showing the HOME screen. To display the HOME
screen, press the menu selectuion button "HOME" on the
control panel.
To check the content of warning messages
Press the SELECT/ENTER dial on the control
panel. A popup window appears to display
messages for the current warnings.
Only one message is displayed at one time, even
if multiple warnings occur. But the number of
current warnings appears at the bottom of the
popup window.
Example:
Popup window displaying warning message
"VTR: 0010 Tele-File FULL"
There is no current error
(see page 188).
There are three current warnings.
To view the other messages, turn the
SELECT/ENTER dial on the control
panel.
When a warning message appears
Take any action that may be needed to eliminate
the cause of the warning.
Warning messages
Code Message
0001 PB FREQ
MISMATCH
Description
System frequency of
this system does not
match system
frequency on the
tape.
Code Message
0002 PB FMT
MISMATCH
0004 NO PB LTC
0005 NO PB VITC
0007 REC INHIBIT
MODE
0008 INVALID FMT
CONV
0009 TEMPERATURE
LOW
000A RTC BATTERY
WARN
000C CP MISSING
000D CAM MISSING
000E TEMPERATURE
HIGH
0010 Tele-File FULL
0011 T-File NO ROOM
Warning/Error Messages
Description
The recording format
of the tape being
played back does not
correspond to the
current format.
Playback LTC cannot
be detected.
Playback VITC
cannot be detected.
The system cannot
record because of a
record inhibit menu
setting. Or the tape is
not formatted for
recording.
Format conversion is
not possible with the
current settings.
The temperature
inside the unit is
lower than the
specified values.
The battery for RTC
(Real Time Clock)
has been exhausted.
Exchange the battery.
The control panel is
not connected. The
main unit operates
normally without the
control panel. On
how to clear this
message, contact a
Sony service
representative.
An internal
communication error
was detected. Power
off and restart the
unit.
The temperature
inside the unit has
risen.
Telefile memory is
almost full. The next
recording will erase
existing data,
beginning with
oldest.
Free memory in a
Telefile has been
completely
exhausted.
191