Hub Reinstallation - Four winns Horizon Owner's Manual

C. Hub Reinstallation
1. To reinstall hub, reverse the procedures listed above.
2. It is important to tighten the spindle nut to approxi-
mately 50 ft. lbs. (12" wrench with full hand force).
Loosen the nut then finger tighten.
3. Replace the cotter.
4. When reinstalling wheel, the following tightening pro-
cedure is recommended by the manufacturer:
a. Place wheel lug nuts on by hand to start.
b. Tighten initially to 15 - 20 ft. lbs. (Apply 20 pounds
of pressure to wrench 12" long) using cross tight-
ening sequence. Proceed to finish tightening
to 85 ft. lbs. (Applying 85 pounds of pressure to
wrench 12" long will yield 85 ft. lbs. of torque).
c. Re-torque after first 50 miles of use.
Refer to Section R-2G for additional information on wheel
requirements.
180/190/200 Horizon
Owner’s Manual
08/01
Section R
Page 14