Table of Contents
Advertisement
SYSTEM
System with Remote Control Unit RM-P2580
Settings
CAMERA FACE
MONITOR
NOT USED
NOT USED
INT
L/L
OFF
ON
TERMINATION
LOCK
SET
LEFT
AWC
UP
RIGHT
DOWN
• Video synchronization selector switch
(INT/LL)
Set to LL (Line Lock) on all cameras, and
align V.PHASE.
(
See page 29.)
• Control signal termination ON/OFF switch
(TERMINATION OFF/ON)
Set this to ON only on the camera placed
at the end of the control signal cable.
Set to OFF on all other cameras.
Menu Screen Settings
COMMUNICATION menu screen
• MODE item: Set to DUPLEX
• STYLE item: Set to MULTIDROP
• ID item: Set the camera ID.
For each camera, match the ID with the
VIDEO INPUT number of the RM-
P2580.
* Settings on the COMMUNICATION
menu screen are performed using the
operation buttons on the front section
of the camera.
MEMO
Following selection of MEMORY, the settings
on the COMMUNICATION menu will not be
valid before the power has been turned on
again.
FUNCTION menu screen
Screen for making settings related to the
Auto Patrol and Auto Pan functions and
display of text.
14
INT
LL
OFF
ON
TERMINATION
• Settings on the FUNCTION menu are
performed using the operation buttons
on the RM-P2580. They cannot be
made using the operation buttons on
the camera body.
• Make settings on other menus as
required.
MEMO
When operating a system using the RM-
P2580, several cameras (up to 16) can be
connected and used on one control signal
cable. Consequently, an incorrect switch
setting on just a single camera will cause
the entire system to work incorrectly.
• Confirm switch settings on the screen
as follows.
q Confirm that the image from the camera
to be checked is displayed on the monitor.
w Turn OFF and then ON the power to the
camera to be checked.
e When the STYLE item is MULTIDROP,
characters similar to those shown in the
figure below are displayed for about 5
seconds. They do not appear in the case
of POINT to POINT.
r Confirm that "DUPLEX" and "ID-MM" are
displayed and that the ID number is the
correct number (the number should be the
same as the number of the VIDEO INPUT
terminal to which the camera is connected
on the rear panel of the RM-P2580).
t If wrong, set the MODE item, STYLE item
and camera ID again.
MONITOR screen
Monitor screen (example showing camera ID as "05")
P R O T
O
C
O
"DUPLEX" should be
displayed.
L : D U P L E X
I D - 0 5
The number shown in
the M M part of ID-
MMshould be correct.
Advertisement
Table of Contents
