Table of Contents
Advertisement
4-9. CASSETTE·UP ASS'Y REPLACEMENT
4~·1.
Removal
_
a. Remove both the FC·9 Mounted Board and
shield plate. (Refer to 4-1)
b. Remove the front panel ass'y. (Refer to 4-2)
c. Remove the blind panel. (Refer to 4-3)
d. Remove the main cover. (Refer to 4-5)
e. Manually set the machine into the Disk-In
mode. (Refer to Fig. 4-9 (a) )
_
f. Remove the damper. (Refer to 4-7)
_
g. Remove the head load ass'y. (Refer to 4-8)
h. Remove the four screws (PSW2.6 x 8) from
the bottom of the chassis, and then remove
the cassette-up ass'y. (Refer to Fig. 4-9 (b»
(aJ Stllllling to Disk-In Modll
(bJ
Cassette-Up
AsS'y
Replacement
CillIJranCtl
ClllaranCtl
Sidll Platll (LBftJ-mf--....l...+---I'
Sidll Platll (RightJ
-33-
(c)
(dJ TDP VIEW of
Cassstte-UpAss'y
Positioning Pin
(eJ
Fig_ 4-9 Cassette-Up Ass'y Replacement
~-2.
Installation and Adjustment
a. Place the cassette-up ass'y onto the chassis
ass'y and fasten the bottom of the chassis
ass'y 'lightly with the four screws (PSW2.6 x
8). (Refer to Fig. 4-9 (b) )
Advertisement
Table of Contents
